Other
Fire exit “new” door beer garden handle
Part of the handle came apart, I found a snapped screw with it. Equipment ID : Beer garden Stage right fire exit door
Sound
Sound Engineer
J-Sub 2R is out. Can very easily hear the audio difference. Needs calibrated. Equipment ID : J Sub 2R
Sound
Sound Engineer
Engine CMOS batter running critically low. Checked the back of the engine and the status looks fine… But worth checking. Equipment ID : Avid S6L
Sound
Sound Engineer
Engine CMOS batter running critically low. Checked the back of the engine and the status looks fine… But worth checking. Equipment ID : Avid S6L
Cabling
Sound Engineer
I think the return box is on its last legs. It’s very noisy. I had to run IeMs from the console, fixed the problem. Maybe just needs replaced at this point. Equipment ID : Return Box
Microphones
Faulty SM58 Beta
One of the SM58 Betas failed to pass sound during ABBA’s sound check. Marked with white tape in the amps room. Equipment ID : SM58 Beta – LQ gig kit
Cabling
Sound Engineer
Dodgy 13 amp plug. It’s the only black one we have so would be good to get fixed soonish. Equipment ID : 13 amp
Other
Metal folding door currently off the wall
Stage left black metal folding door (3 piece) came off the wall, not sure what happened, found it this way on Friday. It’s currently standing. Equipment ID : N/A
Cabling
16 amp cable (DJ to stage Source)
16 amp cable (from DJ desk to stage source) failed. We ran another cable to source. Equipment ID : N/A
Other
Projection Screen Issue
For the darts event, the students wanted the projection screens down. However it looks like the power cable has been chopped to the control switch, and the switch itself is smashed. The socket is missing from the cable to the Read more…
Cabling
Faulty NL4 Cable
Long NL4 faulty. Missing top end when noise tested. Marked with blue tape on the connections. Separated and placed in the amps room. Equipment ID : Long NL4
Cabling
Damaged NL4 loom
The NL4 loom has another damaged line, this time the #1. There’s a noticeable crack just off one of the pins. On the wedge it means there’s a loss of low and mid range. Equipment ID : 4-way NL4 loom
Fixtures
Cells out in Molefay’s
There are cells out in all the 4 cell molefay’s except Centre Stage Left one, which has all cells working. Have attached a photo. Equipment ID : 4 Cell Molefay
FX
C02 Cannons
CO2 Cannons worked fine most of the night. I used them maybe about 5/6times without a problem. But towards the end of the night, the last 2 times I tried to use them, they came on but no fog came Read more…
Fixtures
Molefay intermittently coming on & off
Centre SL Molefay intermittently cuts out when on. It stays off for a few minutes and then comes back on. Then cuts off again and comes back on after a few minutes. Keeps repeating this cycle. Equipment ID : Molefay
Fixtures
Quantum not outputting light
US centre left quantum not outputting any light. Still receiving power and data but no light output. Equipment ID : Mac Quantum
Fixtures
Mac Era 300
No light output, everything else ok. DJ Truss 2nd in from right (FOH) Equipment ID : Unknown
Fixtures
Blinder Cell Not Working
Outer Stage Left blinder’s on stage cell appears not to be not working. Photo attached. Equipment ID : SL outer Blunder
Speakers
Sound Engineer
Fairly sure there is a problem with the input on one of the m4s. It sounds odd, not like a tweeter is gone but just odd, tried the same NL4 with a different cable and it was fine. It’s in Read more…
Sources
Sound Engineer
Send 4 on the analog return multi appears to be faulty. Tried multiple XLR from the same output and it has happened on multiple different gigs so it has to be that. I’ve taped it up. Equipment ID : Analog Read more…
Lighting
Low output from Hazer
The pea soup hazer machine appears to have a low output level. I have to run it at full just to get some haze out of it. Previously I would not have run it so high. Equipment ID : Pea Read more…